The CZCO is a wired zone controller with the ability for the end user to adjust set points, airflows etc. The CZCO also incorporates an occupancy sensor that can be configured to adjust the set point or close the zone or both if no movement is detected after a period of time. To see where a CEXT is connected into a typical system click here

 

Zone name

The Zone name is displayed here. It can be changed on the touch screen or via the App

Max Airflow setting

The current airflow setting is displayed here. It can be adjusted by pressing the airflow button and using the increase and decrease buttons to adjust the maximum airflow

Open Zone

Press here to open the zone fully. (It will open to the maximum airflow setting

 

iSense Activate / Deactivate

Press here to activate or deactivate the iSense control. When activated it the eye will open and the controller will be looking for movement to.

Press and hold this button to configure the iSense settings

 

Movement sensor

The sensor looks for movement to automatically control the zone.

 

Setpoint Temperature

This is the desired set point temperature. In the climate control mode press the increase and decrease arrows to change the setpoint temperature.

Time

Displays the iZone system time. This can be changed on the touch screen or in the App

Indicates iSense is Active

An open eye indicates the movement sensor is active. If the eye is closed the movement sensor has been deactivated and will not automatically control the zone from movement in the room.

 

Current Zone temperature

This is the actual temperature in the zone at present.

Supply air temperature

This the temperature of the supply air in the ductwork. (Indicative only)

Close Zone

Press here to close the zone to its minimum setting

 

Climate Control

Press here for the zone to automatically open and close to control the temperature in the zone. It will be over ridden if the iSense is active and the room is not occupied for the required time.

 

Increase

Use this button to increase the setting

 

Airflow adjustment

Press this button to change the maximum airflow to the zone.

 

Decrease

Use this button to decrease the setting

 

RJ45 connector on back

The RJ45 connects CFC12 or CFC25 to a C225 or CNEM modules

System reset button on underside

The reset button is recessed on the underside of the controller if pressed the whole iZone system will go into initialisation and reset.

 

 

 

iSense Controller Specification

 

Model numbers

CZCOW, CZCOO, CZCOB

Power supply

From RJ45 connector

Movement detection

Range - 7 meters (approx)

Viewing angle - 120(approx)

Casing material

Polycarbonate and ABS plastic

Facia colours available - White, Ocean Mist, Black

Operating Temperature

80 to -14oC

Communications protocols

CAN Bus - Wired

Communication range

35 meters.

(If the cable length is increase longer than 35 meters the reading will not be accurate)

O/A Dimensions

Height   20 mm

Width    72 mm

Length  116 mm

Weight

 132 g

 

 

 

 

Copyright © 2022 iZone Pty Ltd