The CR is a wireless repeater that is used to extend the range of the iZone wireless communications network.

To see where a CR is connected into a typical system click here

 

 

Pair button

The pair button is used to pair the CR to the system

Activity LED

Indicates activity on iZone Net (RF or CAN)

iZone C225 LED

The LED is on, when connected to a C225 module, or off when not connected to a C225 module

 

 

iZone CR Repeater Specification

 

Model numbers

CR

Power supply

Built in or separate

AC/DC Adaptor

Input: 100-240V ~0.3A 50-60Hz

Output: 5V ~1A

Casing material

Fire retardant ABS plastic

Operating Temperature

Up to 45oC

Communications protocols

RF 433 MHz

 

O/A Dimensions (With power supply assembled)

Height   60 mm (Excludes Antenna)

Width    61 mm

Length   110 mm

Weight (With power supply assembled)

 213g

 

 


 

How to separate the power supply from the repeater

 

Sometimes it is preferable to have the repeater on a desk next the router and the power supply plugged into a GPO or power board under the desk. To facilitate this requirement the iZone repeater can be broken down to a power supply and repeater with an interconnecting power lead.

 

The power pack and repeater can be separated as follows.  Using a Philips screw driver, remove the two screws at the base.  Separate the two halves. Remove the power adaptor and discard the base.

 

(CL5B shown in these pictures however the process is exactly the same for CR)

 

 

       

 

 

 

Copyright © 2022 iZone Pty Ltd